Note: This screen will not appear unless "Unlisted Remote" was selected on the "Select Remote Model" screen.
This screen enables the user to "train" Beyond TV to use the IR Blaster by using the receiver box's remote control.
Set the remote control and IR Blaster on a flat surface about six inches (approx. 15cm) apart. Point the remote at the IR Blaster's front and hit the "Train" button to begin. Follow the instructions in the box in the middle of the screen. Once each of the boxes contains a check mark, Beyond TV has been trained with the appropriate frequencies. If necessary, hit the "Reset" button to start over.
It may take up to a minute for some key presses to be detected. If it takes longer than that, try varying the distance between the remote and the IR Blaster, and press the appropriate button again.
When training is finished, hit NEXT and proceed to the following section of this document.
